Microsoft
Software
Hardware
Network
Question : Connect Catalyst switch 2950 to a fiber optic line
Hi
we had 2 site, and this 2 sites is connected via fiber optic lines
so site 2 has
SuperStack® PS Hub 50 24-port
where the output of fiber optic line is connect to a 100Base T (rj45 port) transceiver module slot ( 100 TX)
Please check the picture at page 42 ( under introduction ,features )
http://support.3com.com/in
fodeli/too
ls/hubs/su
prstac/3c1
6405/
manua
l.a02/1640
5ug2.pdf
Now i want to replace this hub with a catalyst 2950 switch
i have connected to the switch but its likes there is not any connection ...link light does not show up ..
will i be able to connect with this switch ???
thanks
Related Solutions:
cisco router ping 2 ms
Answer : Connect Catalyst switch 2950 to a fiber optic line
to change the settings on the port
conf t
int fa 0/x
speed 10 | 100 | auto
duplex half | full | auto
Random Solutions
VBScript to check if a account exist then what memebership it has
Sharepoint 2010 and default IIS
Oracle Fail Safe Setup
How to ensure only one user at a time uses the MS access application?
Remove Webroot Spy Sweeper 3.1
Cannot boot into Windows 7 partition (Blinking cursor) after using Acronis Disk Director resize
VMware, vSphere Virtual Machine and Disk Errors "invalid disk type 7" and "cannot detect guest operating system type"
Network Installation/Setup
namespace question
How to map external ip to internal subnet on a Cisco ASA