Microsoft
Software
Hardware
Network
Question : UC540 newbie here cannot get UC540 to answer
Ok,
#1. I am a newbie at this, so bear with me.
I have a brand new UC540.
I have a 7945G phone connected to one of the PoE ports.
The phone is recognized by the UC540.
I have connectivity to the Internet.
I set up users, extensions, hunt groups etc.
I set up the Incoming Dial Plan as follows: FXO-0/1/0 with Destination Type of "AUTO_ATTENDANT1 (398)"
I recorded a Prompt using the Sound Recorder and an external microphone. Under the AA tab, my Menu Prompt = Cliff1.wav (the file I just created using the microphone and UC540).
Not sure if this matters, but I am using the AA script of: aa_sbcs_v02.aef
My AA extension is: 398 (but my 7945 phone does nothing when I call it)
My AA PSTN Number is the number I use to call my house (not sure if this is correct).
AA Mode is set to: Standard
I connected my analog phone line (FXO) to my FXO 0/1/0 port. This port is in an Active Status acc. to the Voice Trunk Settings.
When I dial my PSTN #, I get connected (acc. to my cell phone), but just get a busy signal.
When I disconnect my PSTN line and connect it to my regular analog phone, it rings.
I have not talked to the phone company about any of this, assuming I can use my existing analog phone line (I could very well be wrong here). Do I need to set up SIP trunks or something like that, with my telephone company?
Answer : UC540 newbie here cannot get UC540 to answer
you can go into the CUEs command line by typing service-module service-engine 0/0 session or "ser se 0/0 se" for short
There is no passwoird attahced usually. Enter enable mmode and do a show run.
Random Solutions
Using Oracle function MAX with date filelds
Dropdownlist - add value
POP3 server unavailable ERR 21
Zindus Google and Zimbra contact sync for Thunderbird problem
Access 2010: Can I start an ACCDE in runtime mode and supply it's password?
New Cisco NAT commands in 8.3
How can i implement the same desktop back ground image on all the computers on my domain
Delphi manupliate string return only integer part
Juniper Netscreen Remote VPN gettting errors 10049 when attempting to connect
xyz..SchemaName.TableName