Question : Cisco 2610XM Stun Configuration Not Working?

Hi All,

We have been asked to build a config and apply them to a pair of Cisco 2610XM with 2 x WIC2T Cards over Serial using STUN. We have the configs perfectly built using templates from other successful installations of the same design. We didn't configure these other sites, but they are all working fine.

However the 2 Cisco 2610XM's we have received will not accept the simplest of STUN commands:

stun peer-name x.x.x.x
stun protocol-group 1 basic

It doesn't seem to recognise the STUN command. I also can't see STUN as a configurable option in the available list of commands when I press "?" under configuration mode...

Here is a copy of the show ver for the boxes:

-----------------------------------------------------------------------------------------------------------------
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(37), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Thu 15-Jun-06 20:48 by pwade
Image text-base: 0x8000808C, data-base: 0x80A1ED58

ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)

Router uptime is 6 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.122-37.bin"

cisco 2610XM (MPC860P) processor (revision 0x200) with 126976K/4096K bytes of me
mory.
Processor board ID JAE08082YT5 (3612219116)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
32K bytes of non-volatile configuration memory.
49152K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102
-----------------------------------------------------------------------------------------------------------------

Do i need to enable something seperate for STUN to engage?

Thanks

Answer : Cisco 2610XM Stun Configuration Not Working?

Hi There

You will need at least an IP Plus feature set in order to configure STUN. It appears from the output that you only have an IP only feature set. Sorry it wasn't the anwser you were hoping for. You might be able to talk to your maintenance provider in order to give you the IP Plus IOS otherwise there will be a cost in upgrading.

Thanks
Erik
Random Solutions  
 
programming4us programming4us